Pumps
Hydraulic power, shaft power, NPSH, specific speed, affinity laws and preliminary pump selection.
Open calculators →Engineering Tools
Oil & Gas Engineering Calculators
Practical, standards-aware calculators for engineers, by an engineer.
Select a discipline to open calculation tools with selectable units, governing formulas, reset controls and calculation history.
AccurateFormulas
StandardsAligned
Multi-UnitConversions
PracticalEngineering Use
Calculator Categories
Select an engineering discipline
Calculation History Control
Delete saved calculation history from every Engineering Calculator on this website.
Piping & Hydraulics
Velocity, Reynolds number, pressure drop, fittings, equivalent length and line sizing.
Open calculators →
Compressors
Gas properties, compression ratio, discharge temperature, head, power and operating checks.
Open calculators →
Ejectors & Eductors
Steam/gas ejector nozzle, mixing, shock and diffuser checks; liquid eductor flow ratio, sizing, cavitation, staging and pump-down time.
Open calculators →
Chemical Injection
Injection rate, pump capacity, tank autonomy, concentration and package sizing checks.
Open calculators →
Tanks & Vessels
Tank volume, liquid inventory, thickness, FRP/GRP calculations, retention time and preliminary sizing.
Open calculators →
Heat Transfer
Heat duty, LMTD, exchanger area, utility flow, effectiveness and insulation calculations.
Open calculators →
Instrumentation
4–20 mA scaling, differential-pressure level, pressure conversion and range checks.
Open calculators →
Engineering Unit Converters
Pressure, flow, temperature, power, energy, viscosity, density and length conversions.
Open calculators →
Electrical Engineering
Load demand, transformers, generators, motors, cable sizing, short circuit, protection and power quality.
Open calculators →
Bulk Material Handling
Material properties, storage bins, conveyors, elevators, feeders, chutes and dust control.
Open calculators →No calculators found
Try another keyword such as pump, piping, compressor, ejector, eductor, tank, electrical, chemical, heat, instrumentation, units, bulk or conveyor.
Engineering-use notice: These tools support preliminary checks, learning and independent verification. Final design must use approved project data, applicable codes, vendor curves, certified software and competent engineering review.